ENGLISH Choose the door opening direction by turning the cupboard 180°. 1.2 Installation The assembly procedure depends on the type of your appliance. There are three types of installation: 1. Cabinets with the plastic top and hinge on the top. 2.
Page 4
Slide two steering screws into the cutouts on the bottom of the cupboard cabinet. To secure the cabinet, fasten the two locking screws (C) directly into the plastic 41 mm top through the drop-shaped holes. Type 2 Screw the two steering screws into the existing holes in the back corners of the appliance .
Page 5
ENGLISH To secure the cabinet, fasten the two locking screws (C) directly into the plastic 41 mm top through the drop-shaped holes. Type 3 Place the assembly brackets (D) along the rear edge of the appliance and mark the positions of the holes. Remove the brackets and drill two 3,5 mm holes where marked.
Make sure the shelf is properly positioned and sta‐ ble. 1.5 Telescope walls assembly Only for models: OT350, OT450, OT500, OT700. 1. Slide the telescope walls upwards to desired height. 2. Fold the lower flap on each side and...
ENGLISH 1.6 Telescope front assembly Only for models: OT350, OT450, OT500, OT700. Place the telescope front with the bended border upwards, towards the back of the cupboard. Adapt the height by folding the front 90° backwards. 90° Assemble the bended border backwards, below the upper edges of the telescope walls.