Brake Burnishing Procedure - Polaris RANGER XP 900 2013 Manual

5. Install the pad adjuster set screw and turn clockwise
until stationary pad contacts disc, then back off 1/2
turn (counterclockwise).
6. Verify fluid level in reservoir is up to MAX line inside
reservoir and install reservoir cap.
Master Cylinder FluidUp to MAX line inside reservoir
7. Install wheel and torque wheel nuts to specification.
TORQUE
Wheel Nuts:Steel Wheels: 60 ft-lbs (81 Nm)
Aluminum Wheels: 120 ft-lbs (163 Nm)

BRAKE BURNISHING PROCEDURE

It is required that a burnishing procedure be performed
after installation of new brake pads to extend service life
and reduce noise.
Start machine and slowly increase speed to 30 mph.
Gradually apply brakes to stop machine. Allow pads and
disc to cool sufficiently during the procedure. Do not
allow pads or disc to become hot or warping may result.
Repeat this procedure 10 times. Do not make more
than 3 stops per 1 mile (1.6 km).
9924880 Rev 2- 1/10/2014 - 2013 / 2014 RANGER XP 900 - 2014 RANGER XP 900 / CREW 900 Service Manual
© Copyright Polaris Sales Inc.
BRAKES
9
9.15