Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
Refer to
Wear eye
instruction
protection
manual
WARNING! Wear approved eye protection. Wear appropriate
Personal Protective Equipment. A full range of Personal Protective
Equipment is available from your Sealey dealer.
WARNING! Ensure that Health & Safety, Local Authority
Regulations and general workshop practice Regulations are
adhered to when using tools.
DO NOT use tools if damaged.
Maintain tools to ensure that they are in an adequate condition for
safe use and optimum performance.
Ensure that a vehicle that has been raised by a jack is adequately
supported. Use axle stands.
Wear suitable clothing to avoid snagging. DO NOT wear jewellery.
Tie back long hair.
Account for all tools, parts and components being used. DO NOT
leave these in or near the engine. Return tools to suitable storage
after use.
These Instructions are provided as a guide only.
Always refer to the vehicle manufactures' service instructions or a
proprietary manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual
cannot cover all possible conditions and situations. The
Operator/ user must apply caution and common sense (good
practical sense).
WARNING! Incorrect or out of phase camshaft timing can result in
contact between the valve head and the piston crown.
This will cause damage to the engine.
2. INTRODUCTION
Setting and locking kit that fits a wide range of VAG group 1.8 & 2.0 petrol engines. Includes essential tooling required to remove the camshaft
adjuster valves and a useful crankshaft pulley holding tool. Some applications and repair operations will require additional tooling.
3. CONTENTS
Item Part No.
Description
1
VS5125-01
Crankshaft Pulley Holding Tool
2
VS5125-02
Crankshaft Spacer Bush
3
VS5125-03
Camshaft Control Valve Tool
4
VS5125-04
Camshaft Control Valve Tool
5
VS5125-05
Camshaft Control Valve Tool
6
VS5125-06
Camshaft Locking Tool
7
VS5125-07
Chain Tensioner Locking Pin
8
VS5125-08
Auxillary Belt Tensioner Locking Pin
© Jack Sealey Limited
INSTRUCTIONS FOR:
SETTING AND LOCKING KIT - VAG
1.8TFSI - 2.0TFSI PETROL CHAIN DRIVE
VS5125
MODEL No:
OE Refs.
Associated Tools
T10355
AK9634M
T10368
VSE2515
T10352
VSE5852
T10352/1
T20208
T40011
T40267
Original Language Version
Description
Mini Dial Gauge
Petrol TDC Position Tool
Service Position Front End Support Guide Set
VS5125
Issue: 3 - 22/03/17