Operating User Interface Features - Electrolux Wave-Touch 137018100 A Use And Care Manual

26

Operating User Interface Features

Setting Preferences, con't
INSTALL CYCLE
Run the INSTALL CYCLE before operating the
dryer the first time. Remove all items from the
dryer drum and press start. For more information
on performing the dryer INSTALL CYCLE, refer to
the Installation Instructions accompanying this
dryer.
If the dryer has been installed according to In-
stallation Instructions,
displayed and the dryer is ready to use.
If the dryer was not installed properly,
CORD , NO GAS
3287 will be displayed to indicate the installation
error.
The errors may result from the following condi-
tions:
• SERVICE CORD
supply cord has been installed improperly or the
house wiring to the receptacle is incorrect.
• NO GAS
between the dryer and the gas line or the valve
is closed.
• CALL SERVICE
calling a qualified technician (1-877-435-3287).
Repeat the INSTALL CYCLE when corrections are
completed.
INSTALL PASS!
or CALL SERVICE 877 435
(electric dryer)—The power
(gas dryer)—There is no connection
—Error can only be corrected by
NOTE
The INSTALL CYCLE is prompted automatically
only once when the dryer is turned on the first
time at the end of installation. After that, if you
wish to run a subsequent INSTALL CYCLE when
moving the dryer or modifying your installation,
you may perform your own INSTALL CYCLE
by selecting it in the set prefs feature and then
following the screen prompts.
will be
SERVICE