Led Indicator; Module Status Led (Mod); Network Status Led (Net) - Hitachi HX-RIO3 Series User Manual

14

4.2.LED Indicator

4.2.1. Module Status LED (MOD)

State
No Power
Device Operational
Device in Standby
IAP Mode
Unrecoverable Fault
*The IP address to access IAP web server during IAP Mode : 192.168.100.10 (Recommended to use Firefox)

4.2.2. Network Status LED (NET)

State
Off-line
On-line (Connect)
Error
Diagnostic
* Blinking MOD & NET LED : BOOTP/DHCP is requesting the address data for new IP address.
(You can change the IP setting mode. Please refer to this manual in the part of IP set-up.)
LED is To indicate
Off No power is supplied to the unit.
Green The unit is operating in normal condition.
The EEPROM parameter is not initialized yet.
Blinking Green
Serial Number is zero value (0x00000000)
Toggle Green/Red IAP Mode : Available for firmware download using Firefox.
The unit has occurred unrecoverable fault in self-testing.
Red
- Firmware fault
LED is To indicate
Off Network Offline.
Green On-line Mode and network is connected.
Red Network Error
Blinking Red Diagnostic Mode
HX-RIO3 Series