Advertisement
【 How to Use the Wristband 】
1. Install an attachment for wristband to the printer.
<CAUTION: For how to install it, see the Attachment for Wristband User's Manual.>
2. Cut the label that fixes the end of the rolled wristband to make it available.
Do not use an outer circumference of the roll, for it is wrapped for protection.
<CAUTION: Peeling off the label forcibly may tear off the wristband or cause the printer malfunction by remaining glue on the printing
surface.>
3. Set the wristband to the printer.
<CAUTION: For how to set it, see the User's Manual for the printer.>
4. Print necessary information on the wristband.
<CAUTION: For print setting of the printer, see "Recommended Print Setting" on the reverse page.>
5. Cut the printed wristband off from the edge by pulling it to both sides.
6. Insert 2 pins on the snap into 2 holes (in one end of the wristband) to the base of the pins.
7. Wrap the wristband around where you attach it, and whlie leaving proper space (of about one
or two fingers), close and fix the snap firmly by inserting the pins on the snap into the holes.
<CAUTION: Wrapping the wristband too tightly may get the skin sweaty or cause a skin
abnormality. Ensure vantilation while using it.>
8. After closing the snap, check whether the snap is firmly fixed by pulling the end of the
wristband.
<CAUTION: If the wristband is not fixed, insert each pin on the snap into the hole in the
wristband and fix it.>
9. Cut the surplus wristband using scissors or a similar tool.
【 Notes After Use 】
After using the wristband, cut it off using scissors or a similar tool.
<CAUTION: Be careful not to hurt the skin.>
<CAUTION: Do not open the snap forcibly once you fix it. Doing so may injure your finger or nail.>
【 Product Materials 】
Product
Wristband
Snap
The wristband and the snap are antibacterial.
Dermatologically tested (by the closed skin patch test).
【 Notes on Storage 】
Do not store the wristbands in locations subject to direct sunlight and high humidity.
Store in an individual box in a cool dark place after opening.
Material
PET+PE
PE
Advertisement
