LG STYLER Owner's Manual page 19

3
Reinstall the filter.
CAUTION
• After cleaning the filter, be sure to install it in
place. If you operate the product without a filter,
the product will not work.
Checking the Aroma Sheet
Use a dryer fabric softener sheet to add a
refreshing aroma to items. Replace the fabric
softener sheet after every use.
1
Remove the aroma filter from the appliance.
2
Open the aroma filter and insert a dryer fabric
softener sheet into it.
a
3
Close the aroma filter and insert it back in the
appliance.
• Insert the aroma filter in the direction of the
arrow. You can adjust the opening of the
aroma filter using the adjustment lever. The
more open the aroma filter is, the richer the
aroma gets.
4
When the cycle is complete, remove the
aroma filter and discard the fabric softener
sheet.
5
Reinsert the aroma filter.
NOTE
• Instead of using a fabric softener sheet, you can
spray perfume 4–5 times on a cotton pad and
then place it in the aroma filter to use. (However,
the fragrance strength can vary depending on
the scent.)
Checking the Water Tanks
Check the water in the water tanks before use. The
water supply tank must be filled with water before
using the appliance. The appliance does not work
without water. The water drain tank should be
emptied before each use.
1
Pull the handle of the tank forward and
remove the tanks from the appliance. Check
the water level of the tanks.
2
Make sure the water supply tank is filled with
water.
• The full water supply tank can be used
approximately four times, depending on the
cycles used.
• Use clean tap water or bottled water for
best performance and longer product life.
Do not use distilled water or reuse the
water from the drain tank.
• The first time the appliance is used, 2/3 of
the water in the fully filled water supply tank
is used. Less water is used in following
cycles.
CAUTION
• Only use water when filling the water supply
tank. Any other substance, such as detergent or
fabric softener, may damage the appliance.
OPERATION 19