Advertisement
How to Install
3. How to Install
1. Uncover the front panel.
3. Attach the Insulator (c) to the rear side of the
base pan.
5. Remove the knock-out from the bottom of the
front panel.
• Take care that drain pan is broken by sharp edge.
• Power cable must not go through the knock-out.
7. Assemble the front panel.
6 Air-to-Water Heat Pump
Tie
Tie
Tie
2. Assemble the Drain pan(b).
- Four pipes are fastened by ties.
- Cut the unnecessary part of ties.
4. Attach the Insulator (a) to the bottom of the
base pan.
6. Insert the Insulator (b) into the front panel.
8. Assemble the Drain pan (a).
- And then connect the drain hose(field
supply) to the Drain pan (a)
Drain Hose
Advertisement
