Preparation Before Marking - Yamaha S20 Service Information

3.5 Preparation before marking

When installing several machines, it is required to install the reference side conveyor correctly
on the marking line and the PCB to be transferred flow smoothly from the top machine to the
last machine.
It is also required to narrow the space between machines as much as possible and reduce
the transferring loss.
This is generally called "marking".

Required tools

Level vial

PCB for marking

Dedicated jig PCB

Steel ruler

46mm wrench

30mm wrench

Sliding paper

Acrylic plates

Hydraulic toe jack

Mini jack

Plumb bob

Manometer

General tools
The accuracy of a desirable level vial (mm/1m) is 0.02
or less.
If the level vial is equipped with the function of
adjusting the height, a shim is not required for
confirming the torsion of the X-beam.
See "3.8.1
Check the X-beam torsion" for
further information.
: At least 2 pcs
: At least 2 pcs
: (Required when connecting our machine to other manufacturer
machines)
: 1m or 60cm steel ruler (If not having them, approx. 3m metal tape
measure can be substitution.)
: At least 2
: Used for S20 and M20 supporting adjuster bolts
: At least 8 sheets
: At least 8 plates
: 4 sets
: 1 set (it is used depending on the situation.)
: Required when marking with ink.
SI1604009E-002= S20, S10, M20, M10 and D10 installation procedures
11/34
For Service Engineer
Service Information