Canon PD-704 User Manual page 2

Introduction
This manual provides the information on the hardware of the Non-Contact Displacement Sensor and the basic
operating procedures. To make full use of the performance and functions of the Non-Contact Displacement Sensor,
please read this manual carefully and understand fully before operation.
Furthermore, please keep this manual in a safe place for future reference.
Conventions
The following conventions are used in this manual.
WARNING
Obey the instructions under this heading to avoid death or serious injury due to fire or electrical shock.
CAUTION
Obey the instructions under this heading to avoid injury or damage to the equipment.
Safety Precautions
General Points to Note
 When starting or operating the equipment, confirm that the performance and functions of the equipment are
working properly.
 In case the equipment malfunctions, take safety measures to avoid various damages.
 If the equipment is used outside the described specifications or altered, the performance cannot be guaranteed.
WARNING
 Do not use this equipment in a place where inflammable or explosive gas or steam is present.
 Never use this equipment with any power source other than one that can supply the correct rated voltage.
 Never perform installation, operation, maintenance, or equipment checks with wet hands.
 Never attempt to disassemble or modify the equipment.
 Never drop the equipment and never subject the equipment to shock or vibration.
 If abnormal symptoms occur, immediately turn off the equipment. (Remove the power cable.)
CAUTION
 When connecting or removing the cable, turn off the equipment and the devices connected to the equipment.
 If the equipment is located near noise sources, use a noise filter, wire the cables, insulate it, etc.
 To use the equipment properly and safely, do not locate the equipment in:
Humid places, dusty places, poorly-ventilated places, and places with high temperature such as those
exposed to direct sunlight
Places with corrosive gas or flammable gas, places subject to direct vibration or shock
Places subject to splashes of water, oil, chemical liquids, etc., places subject to static electricity
Non-Contact Displacement Sensor User's Manual Rev 1.00
2