Optional Parts; How-To" Install The Wheel - Yamaha EF12000DE Owner's Manual

OPTIONAL PARTS

"HOW-TO" INSTALL THE WHEEL

(
1) Checking of supplied accessories
(2) Tool preparation
I
Hoist or square bar (100 mm (3.94 in) by 100 mm (3.94 in), length : 700 mm (27.56 in))
I
Pliers
I
Spanner or socket wrench (12 mm (0.472 in)), 2 units
(3) Installation procedures
(a) Raise the generator by about 100 mm (3.94 in), with hoist or with square bar put under
the bottom panel.
(b) Attach wheel mounting parts ①, ②, stopper ⑨, using clamp ⑩, ⑧, and wheel ③, to
wheel shaft ④.
Then check that wheel ③ is rotated smoothly. If moving turns out to be too complicat-
ed, assemble them together using grease. (4 locations / 2 pieces)
(c) Bend the tip of ① according to the shape of wheel shaft ④ as possible.
(d) Attach the assembled shaft to the foundation plate of the engine, using ⑤, ⑦, and ⑧.
(e) Attach the other shaft to the foundation plate of the generating unit, using ⑥ and ⑦.
(⑧ is not used.)
The tightening torque of bolts should be
⑦
①
②
③
①
②
⑥
③
⑦
④
⑥
⑦
REMOTE CONTROL UNIT
When the remote control unit is connected, the engine will not start unless both starter
switch on the control panel and the engine switch on the remote control unit are switched
on.
⑤
④
③
②
⑤
⑧
⑩
⑧
⑨
①
③
20–25 Nm (
2.0–2.5 m·kgf, 18–22 ft·lbf).
WARNING
If you provide the generator with wheels,
always be sure to place the generator on
⑦
a level surface, locking the wheel with
the stopper and /or chocking the wheels.
①
− 39−