Advertisement
GHVFULSWLRQ
6WHS
Enter into the enable modus of the
router
6WHS
Enter the password to get into the
enable modus (this entry is not
visible)
6WHS
Enter into the configuration modus
of the router
The following output will appear
6WHS
set the ip for modem1
6WHS
Enter ctrl-z
The following output will appear
6WHS
log onto the modem
The following output will appear
6WHS
Enter the username
6WHS
Enter the password (not visible)
The following output will appear
6WHS
Echo on
The following output will appear
6WHS
Reset to factory settings.
1RWH: 0 is „zero"
The following output will appear
6WHS
Press ctrl-shift-6
6WHS
6WHS
Disconnect from the modem
6WHS
Confirm that the connection to
modem1 shall be closed
6WHS
Now your modem and your router are ready to be remotely configured by SIEMENS Remote Services.
$SSHQGL[ * ,6'1 XVH RI WKH DQDORJ URXWHU
1RWH Should it become necessary to switch from the analog connection to an ISDN connection, the
configuration can be done via the analog interface of the router.
Siemens Remote Service
Installation instruction
jac0356323qc828>
password:
jac0356323qc828#
Enter configuration
commands, one per line.
End with CNTL/Z.
jac0356323qc828(config)#
jac0356323qc828(config)#
3d22h: %SYS-5-CONFIG_I:
Configured from console
by console
jac0356323qc828#
Trying modem1
(10.6.254.2, 2001)...
Open
User Access Verification
username
password
Password OK
OK
OK
jac0356323qc828#
Closing connection to
modem1 [confirm]
COIT-000.812.06.022.02
Rev. 02
02-02
5RXWHU SURPSW
Seite 13/13
CO SGK
FRPPDQG
HQDEOH
SUHVHF
FRQILJXUH WHUPLQDO
LS KRVW PRGHP
A]
PRGHP
SUHUGLDJ
SUHVHW
DWH
DW I Z
A>VKLIW@
[
GLVFRQQHFW
FU!
H[LW
Siemens AG
Medical Solutions
Advertisement
