Advertisement
10 www.electrolux.com
2. PURIFIER function + SLEEP mode will
have lower noise than COMPLETE +
SLEEP, as the dehumidification function
is turned off.
NOTE:
• In SLEEP mode, cannot set the target
humidity and the fan speed.
• In SLEEP mode, the display elements
are dimmed to 0% or turned off
completely to be non-disturbing.
5.5 To Run in Continuous
Operation
1. Choose COMPLETE function +
MANUAL mode, then tap the " "
button to reduce target humidity setting
below 35% till the display shows "CO"
and the appliance enters Continuous
operation.
2. To exit Continuous Operation (CO)
function, tap the "
You can also adjust the target humidity
setting above 35% to exit this function.
5.6 Swing
The air outlet in the appliance has an
in-built louvre. You can turn on this feature,
for the louvre to automatically move up &
down continuously so as to better direct
the air flow.
1. Tap "
swing feature, the louvre will swing up
and down automatically.
2. Tap the button again to stop the louvre
at your desired angle/direction.
NOTE:
• Please do not adjust the position of
louvre by force with hand.
" or "
" button to enable the auto
• Please ensure louvre is NOT stopped at
completely closed position when
deactivating SWING feature and
appliance still operating, as this cause
overheating.
5.7 Timer
The TIMER feature allows you to have
either a Delayed Start OR Delayed Stop
for the appliance, in increments of 0.5 to 1
hours (up-to a max of 24 hours).
1. When the appliance is on, tap "
button and display should change to
"0.0" with blinking to reflect Delayed
Stop is initiated. Tap or hold " " and
" " button to change the time by 0.5
hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours.
The appliance will count down the time
remaining, until appliance switches OFF
by itself.
2. When the appliance is off, tap "
" button.
button and display should change to
"0.0" with blinking to reflect Delayed
Start is initiated. Tap or hold " " and
" " button to change the time by 0.5
hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours.
The appliance will count down the time
remaining, until appliance switches ON
by itself.
3. The selected time will be set as target
(registered) when user does not interact
with control panel for 5 seconds after
choosing desired time; indicated when
screen stops blinking. Once time is set,
display screen will revert back to show
humidity levels.
4. To exit & cancel the timer feature, turn
the unit ON/OFF by pressing the power
button anytime OR adjust the timer
setting to "0.0" hours.
NOTE:
• Before entering TIMER setting, make
sure power is being supplied to the
appliance.
"
"
Advertisement
