Table of Contents
Advertisement
1.SAFETY OFPERATION RULES
1. SECURE WORK. Use chuck to hold workpiece when practical. It's more safer
than using your hand and it frees both hands to operate tool.
2. DON'T OVERREACH. Keep proper footing and balance at all times.
3. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for the best and
the safest performance. Follow instructions for lubricating and changing
accessories.
4. DISCONNECT TOOLS before servicing, when changing accessories such as
cutting tools.
5. REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure switch is in
off position, before intend plugged in.
6. USE RECOMMENDED ACCESSORIES. Consult the owner's manual for
recommended accessories. The use of improper accessories may cause risk
or injury to persons.
7. NEVER STAND ON TOOL. Serious injury could occur, if the tool is tipped or
if the cutting tool is unintentionally contacted.
8. CHECK DAMAGE PARTS. Before further use or the tool, a guard or other part
that is damaged should be carefully checked to determine that it will
operate properly and perform its intended function, check for alignment of
moving part binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other part that is
damaged should be properly repaired or replaced.
9. NEVER LEAVE TOOL RUNNING UNATTENDED TURN POWER OFF. Don't leave
tool until it comes to a complete stop.
10. ALWAYS USE SAFETY GLASSES. Common eyeglasses only have impact
resistant lenses, they are NOT safety glasses.
11. KEEP GUARDS IN PLACE and in working order.
12. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to
see that keys and adjusting wrenches are removed from tool before turning
it on.
13. KEEP WORK ARE A CLEAN. Cluttered areas will invite accidents.
14. DON'T USE IN DANGEROUS ENVIRONMENT. Don't use power tools in
damp or wet location, or expose them to rain. Keep work area well lighted.
15. KEEP CHILDREN AWAY. All visitors should be kept safe distance from work
area.
16. MAKE WORKSHOP CHILD PROOF with padlocks, master switches, or by
removing starter keys.
17. DON'T FORCE TOOL. Don't force tool or attachment to do a job for which
it was not designed.
18. USE RIGHT TOOL. It will do the job better and safer at the rate for which
it was designed.
19. WEAR PROPER APPAREL. No loose clothing, gloves, neckties, rings
bracelets, or other jewelry to get caught in moving parts. Non-slip footwear
is recommended, wear protective hair covering to contain long hair.
20. Never use the high speed over one hour.
21. KEEP TURNING TOOLS TIGHT during operating.
02
Advertisement
Table of Contents
