Switches / Controls; Brake Light Switch; Headlamp Switch - Polaris RZR 800 2013 Manual

ELECTRICAL

SWITCHES / CONTROLS

Brake Light Switch

1. The brake switch can be accessed by removing the
driver's seat (RZR / RZR S) or the left rear
passenger seat (RZR 4). The switch is located under
the outer PVT cover along the lower frame. The
brake pressure switch is installed into the cross
fitting block.
2. Disconnect wire harness from switch and connect an
ohmmeter across switch contacts. The reading
should be infinite (OL).
3. Apply the brake and check for continuity. If there is
no continuity or if resistance is greater than 0.5
ohms, clean the switch terminals. Re-test and
replace switch if necessary.
10.4

Headlamp Switch

1. Disconnect the headlamp switch harness by
depressing the connector locks and pulling on the
connector. Do not pull on the wiring.
2. Test between the 3 sets of outputs (OFF / LOW /
HIGH). If any of the tests fail, replace headlamp
switch assembly.
• Move the switch to HIGH. There should be
continuity between switch pins 2 and 3; 5 and 6.
• Move the switch to LOW. There should be
continuity between switch pins 2 and 3; 4 and 5.
• Move the switch to OFF. There should be
continuity between switch pins 1 and 2; 4 and 5.
NOTE: Pins 7 and 8 provide power and ground
to light the switch lamp.
9924707 - 2013–2014 RZR 800 Service Manual
© Copyright 2013 Polaris Sales Inc.