Cleaning And Lubrication Of The Operating Mechanism - ABB SACE Emax 2 Installation, Operation And Maintenance Instructions

Cleaning and lubrication of the
operating mechanism
54 | © 2021 ABB | 1SDH002083A1002 - ECN000119014 - Rev. A
To clean and lubricate:
1. Clean the closing clip, the closing rod and opening rod in the points shown in the illustrations. If there
is a thick build-up of dirt, use a thinner from the greasing kit or ask for assistance from the service staff.
2. Lubricate closing hook, the closing shaft, opening hook and opening shaft in the points indicated by
the illustrations with Mobilgrease 28 grease (EXXON MOBIL).
3. Make sure that the opening and closing shafts are free to turn.
Figure 79 - Lubrication of closing latch and shaft
Figure 80 - Lubrication of the closing hook
Figure 81 - Lubrication of opening latch and shaft
Putting into service and maintenance | 5 - Second level maintenance
ABB | SACE Emax 2
Continued on the next page