Accessing Internal Components - Toro TX 1300 Operator's Manual

Removing and Storing the
Cylinder Locks
Important:
Remove the cylinder locks from the
rods and fully secure them in the storage position
before operating the machine.
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Shut off the engine and remove the key.
4. Remove the pins securing the cylinder locks.
5. Remove the cylinder locks from the lift-cylinder
rods.
6. Insert the pins into the locks.
7. Place the cylinder locks on the loader arms, with
the pin rings beneath the locks, and secure each
lock using the hand knob.
Figure 59
1. Pin
2. Cylinder lock
8. Lower the loader arms.
g359013
3. Hand knob
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
Opening the Hood
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Unlock the hood using the latch key and press
the button to release the latch.
4. Lift open the hood
Closing the Hood
1. Lower the hood.
2. Press down the latch to secure the hood.
3. Lock the hood using the latch key.
43
Figure 60
g362359