Cannot Print Properly From The Digital Camera - Canon PIXMA Pro9000 Series Quick Start Manual

Troubleshooting
Problem
A specified period
of time has elapsed
"Error No.: 2001"
without receiving a
response from the
digital camera/The
digital camera or
digital video
camcorder
connected is not
compatible with
this printer
Automatic Print
Head alignment
"Error No.: 2500"
failed

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a digital still
camera or digital video camcorder*, and the countermeasures to eliminate them.
*Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera.
Camera Error Message
Printer in use
No paper
Paper Error
80
Possible Cause
Disconnect the camera cable and reconnect it.
If the error is still unresolved, there is a possibility that you are using a digital
camera or digital video camcorder that is not supported by this printer.
PictBridge-compatible digital camera or digital video camcorder can be
connected to your printer for Direct Printing.
See "Eleven flashes" in
Possible Cause
Images are being printed from
the computer
The printer is warming up
No paper in the Auto Sheet
Feeder
The printer is not ready to
feed paper from the Front Tray
yet (the ALARM lamp on the
printer is lit orange.)
The Front Tray or the Rear
Support is closed (Printer
ALARM lamp flashes orange
three times.)
The Inner Cover is open
(Printer ALARM lamp flashes
orange six times.)
The Front Tray is not set to its
correct position or the Front
Tray was moved during
printing (Printer ALARM lamp
flashes orange ten times.)
Try This
Depending on the model or brand of your PictBridge compliant
device, you may have to select a print mode before connecting the
device.
You may also have to turn on the device or select Play mode
manually after connecting the device to the printer.
Perform necessary operations according to the instruction manual
supplied with your device.
"Handling Error Messages"
Wait until printing ends. The printer automatically starts
printing the images from the camera after completing the
current printing.
Wait until warm-up ends. When it is ready, the printer starts
printing automatically.
Load the paper in the Auto Sheet Feeder, and select Continue
in the display on your camera.
Load the paper correctly in the Front Tray according to the
procedure described in
page 10 and press the RESUME/CANCEL button on the printer.
If the Front Tray is closed, open it to resume printing.
If the Rear Support is closed when printing from the Front Tray,
open it and select Continue
Close the Inner Cover and select Stop in the display on your
camera to stop printing.
When printing from the Auto Sheet Feeder, return the Front Tray
to its normal printing position. Ensure that paper is loaded in
the Auto Sheet Feeder and then select Continue
on your camera to resume printing.
Refer to "Returning the Front Tray to Its Normal Printing
Position" on page 14 for details about how to return the Front
Tray to its normal printing position.
If you have moved the Front Tray during printing, select Stop in
the display on your camera to stop printing.
Return the Front Tray to the correct position, and try printing
again.
Do not move the Front Tray during printing.
on page 73.
Try This
"Loading Paper in the Front Tray"
*1
in the display on your camera.
*1
*1
on
in the display