Copying data from P cards to the hard drive (continued)
Switching to the USB HOST mode
1
Hold down [POWER] for at least 1 second to
turn the power on.
The thumbnail screen now appears.
Press [THUMBNAIL/MODE] to display the
normal display screen.
Press [MENU/MODE CHK].
Using
,
and
FUNCTIONS" – "PC MODE SELECT", and
press
.
5
Using
and
press
.
6
Press [MENU/MODE CHK] twice to display
the normal display screen.
Usable hard drives
The following hard drive can be used.
•
Panasonic portable hard disk unit for P2 store (AJ-PCS060G)
•
Any hard drive which can be connected using USB 2.0
•
USB bus power (5 V, 0.5 A) is also supported, but some hard drives cannot be started up using it. If this
is the case, supply power from a separate source to the hard drive.
•
Some hard drives may not operate properly.
•
Do not use USB memories or other removable media.
6
, select "OTHER
, select "USB HOST", and
Hold down [THUMBNAIL/MODE] for at least
seconds.
The USB HOST mode is now established,
and "USB HOST" appears at the bottom of the
thumbnail screen.
•
Use a hard drive with enough memory to
accommodate the data to be copied.
To exit the USB HOST mode
1
Hold down [THUMBNAIL/MODE] for at least
seconds.
The USB HOST mode is cancelled, and "USB
HOST" disappears at the bottom right of the
screen.