Table of Contents
Advertisement
Changing the input signal
The input source for picture signals can be changed by pressing TV/VIDEO, SD on the Remote
Control or CH up/down on the unit.
Remote Control
Device display Unit
Video 1
Signal of source connected to INPUT 1 is displayed.
Video 2
Signal of source connected to INPUT 2 is displayed.
Video 3
Signal of source connected to INPUT 3 is displayed.
Comp 1
Signal of source connected to COMPONENT VIDEO INPUT 1 is displayed.
Comp 2
Signal of source connected to COMPONENT VIDEO INPUT 2 is displayed.
Comp 3
Signal of source connected to COMPONENT VIDEO INPUT 3 is displayed.
RGB 1
Signal of source connected to RGB IN 1 is displayed.
RGB 2
Signal of source connected to RGB IN 2 is displayed.
HDMI
Signal of source connected to HDMI IN is displayed.
Photo (Photo Viewer)
Signal of source connected to CARD SLOT is displayed.
The input mode changes each time this
button is pressed.
* If SKIP is set as the Input Label setting
of Channel Caption, the mode will not be
changed. (See page 69.)
Card input mode (Photo Viewer) is
selected.
By pressing Channel Up/Down buttons
together, you can switch between TV
mode and an outside input source.
1
*
Changing input is only possible if
Cable/Antenna is set as the Input Set
setting.
2
*
Input changes to the fi rst outside input
source of the Input Label not set to SKIP.
For example, if Video 1 is set to SKIP, input
is changed to Video 2. See the chart, below
(except for Photo mode).
While Photo Viewer is displayed, the
channel or outside input source last
viewed is redisplayed.
Device display operation
TV
HDMI*
Video 1*
RGB 2*
Video 2*
RGB 1*
Video 3*
Comp 3*
Comp 1*
Comp 2*
Video 1*
TV
Antenna A
1
Antenna B*
2
37
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
