Table of Contents
Advertisement
[B] Pre-assembling the pole brackets and bands (non-grooved band
type)
1.
2.
3.
4.
5.
6.
Figure 13.
DN991456
© Nokia Corporation
Issue 3 en
Nokia Proprietary and Confidential
All manuals and user guides at all-guides.com
Assemble the locking device by inserting the end of the locking rack into
the worm screw housing and turning the screw to engage the rack. Make
sure you have the rack the right way round when doing this. The words
'THIS SIDE UP' should be visible on the rack when the locking device is
clamped around the pole. Refer to Figure 12.
Cut the metal band to the appropriate length, according to the pole
diameter. Refer to Table 8 above.
Route the metal band through the holes in the front block.
Bend one end of the metal band over to form a hook of about 30 mm (1.2
in) in length.
Insert the hook into the slot at the end of the locking rack.
Bend the other end of the metal band over to form another hook of about
30 mm (1.2 in) in length. Leave it free for now.
Locking
rack
Pole bracket pre-assembled (large-pole mounting kit)
Worm screw
Worm screw
housing
Metal
band
Mounting the BTS
43 (72)
Advertisement
Table of Contents
