Table of Contents
Advertisement
INSTALLATION AND CONNECTIONS
To Install batteries :
Your REMOTE CONTROL HANDSET is
powered by two AAA type batteries.
1. To insert them, push the tab backwards and lift
off the cover of the handset.
2. Put the two batteries into the compartment
making sure the + and - are correctly
positioned.
3. Replace the cover.
INSTALLATION AND CONNECTIONS
R
L
AUX
IN
CD
IN
IN
TAPE
OUT
ANALOG
R
L
OUT
CDP
OUT
CDR
IN
ANALOG
R
L
OUT
NOTE : When replacing batteries, it always a
good idea to replace both at the same time.
When the remote will not be used for an
extended period of time, it is also a good idea to
remove the batteries to avoid the possibility of
damage due to corrosion. Batteries contain
chemical substances and we recommend that
you dispose of them properly and in compliance
with any local regulations.
COAXIAL
DIGITAL
IN
IN
OUT
OUT
COAXIAL
OUT
OUT
CDR
IN
IN
OUT
DIGITAL
OPTICAL
OUT
OUT
RECEIVER
OPTICAL
IN
OUT
AUDIO CD RECORDER
ADR-620
CD PLAYER
- 13 -
Power Connections
Connet the AC Power Cord to an AC power
source. If the rear-panel AC outlet on a receiver
or other product is used, make certain that it
provides at least 48 watts, and that the total
power of all products connected does not exceed
the maximum rated output of the product
containing the outlets. If the unit is connected to a
switched outlet, remember to turn on the outlet or
product controlling it in order for the unit to
operate.
Advertisement
Table of Contents
