Frigidaire FED367DSB Installation Instructions Manual
30" electric drop-in range
Hide thumbs
Also See for FED367DSB:
- Wiring diagram (2 pages) ,
- Use & care manual (28 pages) ,
- Installation instructions manual (13 pages)
Table of Contents
Advertisement
Available languages
Available languages
Quick Links
30" ELECTRIC DROP-IN RANGE INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Shave Raised
Edge To Clear
Shave Raised Edge To
Clear 31 1/2" (81 cm)
30" (76.2 cm)
Wide Cooktop Rim.
Wide Cooktop Rim
1-½ " Max.
(3.8 cm Max.)
Locate
Cabinet Doors
1" Min. from
C
Cut-Out
Opening
*Note:
NOTE
:
For
29" (73.7 cm)
29" (73.7 cm)
Wide Opening
cutout wide opening,
For Overlapping
you must call for optional
Cooktop And
side panels and clear wide
Built-In Look
cooktop rim as shown on
page 4.
Do not pinch the power supply cord between the range
and the wall.
Do not seal the range to the side cabinets.
*NOTE: Allow at least 20" (50.1 cm) clearance for door
depth when it is open.
**NOTE: 24" (61 cm) minimum clearance between the
cooktop and the bottom of the cabinet when the bottom
of wood or metal cabinet is protected by not less than 1/
4" (0.64 cm) flame retardant millboard covered with not
less than No. 28 MSG sheet metal, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum, or 0.020" (0.5
mm) copper.
30" (76.2 cm) minimum clearance when the cabinet is
unprotected.
(58.1 cm) min.
(59.05 cm) max.
(2.86 cm)
FRONT
OF
CABINET
* For cutouts below 22 7/8", appliance
will slightly show out of the cabinet.
A QUALIFIED INSTALLER.
30"
(76.2 cm Min.)
30" Min.**
(76.2 cm Min.)
18" Min.
(45.7 cm Min.)
A
31 1/2"
30"
(81 cm)
(76.2 cm)
Exact
Exact
Approx. 1-7/8"
B
(4.8 cm)
Grounded Junction Box
in adjoining cabinet
22 7/8"*
23 1/4"*
1 1/8"
B
Ref.
AT REAR OF RANGE
48" (122 cm)
Armored Cable
NOTE: Two sets of holes are provided
under anti-tip bracket. Bracket is
attached in the upper hole position at
the factory.
24" Min.
(61 cm Min.)
A. Cutout Width B. Cutout Depth
30 ±
1/16
"
(76.2 ± 0.15 cm)
* Door open
(see note)
30"
(76.2 cm)
Figure 1
1
Smoothtop Models
ANTI-TIP BRACKET
C. Height of
(According to front
Cutout
of cabinet)
29" (73.7 cm)
21 3/4" (55.2 cm) min
22 1/8" (56.2 cm) max
28 5/16"
(71.9 cm)
21 3/4"
(55.25 cm)
P/N 318201608 (0311) Rev. B
English - pages 1-6
Español - páginas 7-12
1 5/16"
(3.3 cm)
29-3/8"
(74.6 cm)
Advertisement
Table of Contents
Related Manuals for Frigidaire FED367DSB
Summary of Contents for Frigidaire FED367DSB
- Page 1 Grounded Junction Box page 4. in adjoining cabinet Do not pinch the power supply cord between the range and the wall. Do not seal the range to the side cabinets. *NOTE: Allow at least 20" (50.1 cm) clearance for door depth when it is open.
-
Page 2: Important Notes To The Installer
They are located in a plastic bag in the oven.For smoothtop models, the anti-tip bracket located at the rear of the range fits under the countertop and prevents range from tipping. Failure to install the anti-tip screws will allow the range to tip over if excessive weight is placed on an open door or if a child climbs upon it. -
Page 3: Electrical Requirements
30" ELECTRIC DROP-IN RANGE INSTALLATION INSTRUCTIONS Electrical Requirements This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse, having amperage as noted on the rating plate (the rating plate is located on the oven frame). -
Page 4: Countertop Preparation
Failure to do so could result in serious injury or death. Countertop Preparation • The cooktop sides of the range fit over the cutout edge of your countertop. • If you have a square finish (flat) countertop, no countertop preparation is required. -
Page 5: Checking Operation
6. This range may be equipped with an anti-tip bracket attached to the back of the range with two screws. If countertop thickness is greater than 1/2" (1.3 cm), relocate anti-tip bracket to the lower position 1/4"... - Page 6 30" ELECTRIC DROP-IN RANGE INSTALLATION INSTRUCTIONS Notes...
- Page 7 INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA EMPOTRABLE DE 30" LA INSTALACION Y EL SERVICIO DEBEN SER EFECTUADOS POR IMPORTANTE: GUARDE ESTAS INSTRUCCIONES PARA USO DEL INSPECTOR LOCAL DE ELECTRICIDAD. LEA Y GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA. Acepille el borde subido a Lije la parte elevade del borde (76.2 cm Min.) para obtener las 31 1/2"...
-
Page 8: Notas Importantes Para El Instalador
INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA EMPOTRABLE DE 30" Notas importantes para el instalador 1. Lea todas las instrucciones contenidas en este manual antes de instalar la estufa. 2. Saque todo el material usado en el embalaje del compartimiento del horno antes de conectar el suministro eléctrico a la estufa. -
Page 9: Requisitos Eléctricos
INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA EMPOTRABLE DE 30" Requisitos eléctricos Este artefacto debe ser suministrado con el voltaje y la frecuencia adecuados, y conectado a un circuito individual correctamente puesto a tierra, protegido por un cortacircuitos o un fusible con el amperio anotado en la placa de calificación (la placa se encuentra en el armazón del horno). -
Page 10: Instalación De La Estufa
INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA EMPOTRABLE DE 30" Figura 3 - Sistema eléctrico de 4 alambres (ejemplo caja de empalme) Donde los códigos locales NO permitan conectar el conductor de puesta a tierra del eléctrodoméstico al neutral (blanco), o si está conectado con un sistema a 4 alambres (vea figura 3): 1. -
Page 11: Comprobación Del Funcionamiento
INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA EMPOTRABLE DE 30" de alambre). Abra un agujero de 1-1/4” (3.2 cm) para traer el alambre hasta la caja de conexiones. 4. Introduzca el alambre eléctrico por el agujero y fíjelo a la caja. - Page 12 INSTRUCCIONES DE INSTALACION PARA LA ESTUFA ELECTRICA EMPOTRABLE DE 30" Notas...