Table of Contents
Advertisement
Quick Power Switch
By pressing quick power switch (1) when the power mode
is OFF, the power mode is temporarily activated. (The
power mode indicator on the monitor shows symbol (
f
NOTE: The quick power switch is operable only in the
following cases.
An added push is needed during digging (tractive)
operation.
Need a little more acceleration or travel speed while
ascending on a slope.
When operating under low load or the forward/reverse
switch is in "Neutral" (N) position, the mode will not
change to power mode even if quick power mode switch is
pressed. The switch selection is ruled invalid.
Also, even if the machine is in the power mode, it is
canceled when the following conditions are met.
When operating load is decreased while digging.
When the quick power mode switch is pressed.
The forward/reverse switch is operated.
While driving in the auto-shift mode, the gear shifts
up to the selected gear stage.
Right Console Slide Lever
Adjust the position of the right console as follows.
1. While tilting lever (2) to the right, adjust the position
of the right console by sliding it back or forth.
Holding and moving armrest (3) maybe easier to
move the console.
Slide quantity: 90 mm (3.5 in)
2. After the adjustment, put back lever (2) to the
original position.
OPERATOR'S STATION
).)
2
1-111
1
Fingertip Control Type
1
Multi-Function Joystick Type
115Z7-1-107-2
MNEC-01-043
3
115MNEC-01-043
Advertisement
Table of Contents
Troubleshooting
