Husqvarna AUTOMOWER 310 Operator's Manual page 45

Message Cause
Charging station
The contact between the charging
blocked
plates on the product on the and con-
tact plates on the charging station may
be poor and the product has made a
number of attempts to charge.
An object is in the way of the product
that prevents it to enter the charging
station.
The charging station is tilted or bent.
The guide wire is not installed correctly. Check if the guide wire is installed ac-
Stuck in charging
There is an object in the way of the
station
product preventing it from leaving the
charging station.
Upside down
The product is leaning too much or has
turned over.
Needs manual
The product is set to the
charging area operating mode.
Next start hh:mm
The schedule setting prevents the
product from operating.
The rest period is in progress. The
product has an inbuilt standby period
according to the Standby time table.
The clock or date in the product is not
correct.
Today's mowing
The product has an inbuilt standby peri-
completed
od according to the Standby time table.
Lifted
The lift sensor has been activated as
the product has been lifted.
Wheel drive prob-
Grass or other object is wrapped
lem, right/left
around the drive wheel.
1440 - 003 - 09.03.2020
Action
Put the product in the charging station
and check that the charging plates and
contact plates make good contact.
Remove the object.
Put the baseplate on level ground.
cording to the instructions. Refer to
install the guide wire on page 22 .
Remove the object.
Turn the product the right way up.
Secondary
Put the product in the charging station.
Change the schedule settings. Refer to
Schedule on page 24 .
This behavior is normal and no action
is required.
Set the time. Refer to
date on page 32 .
This behavior is normal and no action
is required. Refer to
Standby on page 37 .
Check that the product body can move
freely around its chassis. Remove or
create an island around objects that
can cause the chassis to be lifted. If the
problem stays speak to your authorized
service technician.
Clean the wheels and around the
wheels.
To
To set the time &
Schedule and
Troubleshooting - 45