Operation; Before First Use; How To Use Surface Burners - Haier HOR54B5MCW1 User Manual

INSTALLATION
a
Fig.C
Adjust the air flow of the oven burner
Caution!
● Adapting the appliance to a different
type of gas than that indicated by the
manufacturer of the cooker on the
data plate, or purchasing a cooker for
a different type of gas than supplied to
the house, is exclusively the
responsibility of the user and the fitter.
●
After adjustment is completed, place a
label indicating the type of gas to
which the cooker is now adapted.
Electrical connections
Electric connection may be carried
out by qualified service personnel
only!
Wrong connection may permanently
damage parts of the appliance and
render your warranty void!
Mains voltage of the user(240V)must
be verified with the measuring device!
Three separrating switches should be
placed in accordance with the mains
connection.
Mains lead behind the cooker must be
●
placed in such manner to avoid
touching the back panel of the cooker
because of the heat it develops during

operation.

11
●
The mains lead extension may be
made by qualified personnel only.
●
Repairs of electrical parts may be
carried out only by qualified
electrician.In case of malfunction call
the service center.
Connection
●
Using the screwdriver open the
connector cover at the rear of the
appliance.Release two locks located
at either side of the connector bottom.
●
Mains lead must be led through the
relief safety device,protecting the
mains leadcable from disconnection.
●
Tighten the relief device securely and
close the connector cover.
Colour code
L=exterior live wires,usually coloured
black .
The colour is usually white.
Beware of the correct N-connection!
E=earthing wire.
The colour is green .
220-240V~50/60Hz
L
N
E
OPERATION

Before first use

 Remove packaging elements,
 Gently (slowly) remove labels from the
oven door, trying not to break the glue
tape. If any visible trace is left on the
glass, warm up the oven chamber (see
below), spray the warmed-up glass with
a glass cleaner, and wipe off with a soft
cloth.
 Empty the drawer, clean off factory
preservatives from the oven chamber,
 Take out and wash the oven fittings with
warm water and a little washing-up
liquid,
 Switch on the ventilation in the room or
open a window,
 Heat the oven (to atemper ature of
250℃，for approximately 30 min.),
remove any stains and wash carefully.
 When handling the cooker, follow the
safety instructions carefully.
The oven chamber should only be
washed with water and a small
amount of washing-up liquid.

How to use surface burners

Choice of cookware
Mind that the diameter of a pan base is
always larger than the burner flame crown,
and that the pan itself is covered. The
recommended pan diameter is around 2.5
to 3 times larger than the burner diameter,
that is, for:
● An auxiliary burner – a pan with a
diameter of 90 to 150 mm,
● A medium burner – a pan with a
diameter of 160 to 220 mm,
● A large burner – a pan with a diameter
of 200 to 240 mm, and the pan height
should not be greater than its
diameter.
RIGHT
WRONG
Gas burner control knobs
Postition
burner"switched off"
Position
"large flame"
Position
"economical flame"
12