9-Troubleshooting - Haier HW70-BP14636 User Manual

9-Troubleshooting

Many occuring problems could be solved by yourself without specific expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶ Electrical equipment should be serviced only by qualified electrical experts, because
improper repairs can cause considerable consequential damages..
▶ A damaged power cable should only be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
The remaining wash cycle time will be 1 hour and 25 minutes
1:25
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
6:30
utes
P--1/2/3 1/2/3 additional rinses are choosen (see FUNCTION BUTTONS „Extra rinse").
The washing cycle is finished. The appliance shuts off automatically.
End
Function child lock is activated
cLo1-
LocI - Door is closed because of high water level, high water temperature or spinning cy-
cle.
bEEP OFF The buzzer is deactivated
The buzzer is activated
bEEP ON
Function "Sped up" is activated
SPEEd uP
9.2 Troubleshooting with display code
Problem Cause
• Drainage error, water is not fully drained
E1
within 6 minutes
• Lock - error.
E2
E4 • Water level not reached after 8 minutes.
• Drain hose is self-syphoning..
E8 • Water protective level - error..
22
Solution
• Clean pump filter.
• Check drain hose installation.
• Shut the door properly.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Contact the After sales
GB
service..