Toro 30363N Operator's Manual page 41

1. Park the machine on a level surface, lower the
mower deck, move the throttle lever to the Slow
position, stop the engine, and remove the key from
the ignition switch. Open the hood.
2. Remove the dipstick (Figure 44), wipe it clean, and
install the dipstick. Remove the dipstick and check
the oil level.
The oil level should be up to the Full mark on the
dipstick.
1. Dipstick
3. If the oil level is below the Full mark, remove the fill
cap (Figure 44) and add oil until the level reaches the
Full mark on the dipstick.
Important: Do not overfill.
Note: Use a clean funnel to prevent spills.
4. Install the oil fill cap and close the hood.
Changing the Engine Oil And Filter
Service Interval: After the first 50 hours
Every 150 hours
Change the oil and filter initially after first 50 hours
of operation and then every 150 hours of operation
thereafter. If possible, run the engine just before
changing the oil because warm oil flows better and
carries more contaminants than cold oil.
1. Position the machine on a level surface.
2. Open the hood.
3. Set a drain pan under the oil pan and in line with
the drain plug (Figure 45).
Figure 44
2. Oil fill
1. Oil filter
4. Clean the area around the drain plug.
5. Remove the drain plug and allow the oil to flow into
drain pan.
6. Remove and replace the oil filter (Figure 45).
7. After the oil is drained, install the drain plug and
wipe up any oil that is spilled.
8. Fill the crankcase with oil; refer to Checking the
Engine Oil Level.
41
Figure 45
2. Drain plug