Lubrication; Greasing The Bearings And Bushings - Toro 31598 Operator's Manual

Figure 48
1. Slide cover inward
approximately 1 inch
6. Lift the front edge, guide it between the lift arm and
the roller to remove it
Figure 49
1. Slide cover out between lift arm and roller
Installation
1. Lower the wing deck onto a level surface.
2. Slide the cover into position by guiding the rear edge
between the lift arm and roller.
3. While sliding the cover away from the traction unit,
guide the outside edge under the front and rear brackets
on the deck.
4. Align the deck mounting posts with the holes in the
cover and lower the cover into position.
5. Install the bolt securing the belt cover, if so equipped.
6. Engage the deck cover latch.
2. Disengage these cover
edges
(Figure 49).

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Before each use or daily—Lubricate castor
arm bushings.
Every 50 hours—Lubricate all grease fittings.
The machine has grease fittings that must be lubricated
regularly with no. 2 general-purpose lithium-base grease. If
the machine is operated under normal conditions, lubricate all
bearings and bushings after every 50 hours of operation or
immediately after every washing.
Note: The castor fork shaft bushings must be lubricated
before each use or daily
The grease fitting locations and quantities are:
Traction Unit
•
2 impact arms (Figure
•
2 front Deck Lift cylinder pivots
•
2 side Deck Lift cylinder pivots
•
4 steering cylinder ball joints
•
2 tie rod ball joints
•
2 king pin bushings
•
1 rear axle pivot bushing
•
1 brake shaft pivot bearings
41
50)
(Figure 50)
(Figure 50)
(Figure 51)
(Figure 51)
(Figure 51)
(Figure 52)
(Figure 53)