Specifications - Toro 30242 Operator's Manual

Specifications

Note: Specifications and design subject to change without notice.General Specifications
Engine
Air Cleaner
Fuel Tank Capacity
Fuel Pump
Cooling System
Electrical
Drive Coupling
Transmission
Hydraulic Filter
Front Axle
Rear Axle
Brakes
Tires
Ground Speed
Main Frame
Instrumentation
Controls
Kubota three-cylinder, 4-cycle, liquid-cooled diesel engine. 26 hp @ 3000. Engine
governed to 3200–3250 rpm high idle, no load.
Heavy-duty remote mounted.
8.5 gal. (32 l) Equipped with a fuel filter/water separator to capture water in the fuel.
12-volt electric (transistor type) w/replaceable fuel filter.
7 qt (6.6 l) capacity. Remote-mounted expansion tank 1 qt (0.946 l) capacity. System
contains a 50/50 mix of ethylene glycol anti-freeze and water. Front mounted air/oil
cooler used to cool hydraulic oil for the hydrostatic transmission.
12 volt with 530 cold cranking amps at 0° F and 75-minute reserve capacity at 80° F.
Transmission driven by steel shaft with flexible rubber couplings at each end.
Hydrostatic, U-type. Implement Relief Setting—700–800 psi (4,826–5,516 kPa).
Replaceable 25-micron filter mounted directly to the transmission.
The front axle serves as a hydraulic fluid reservoir and mates directly with the
transmission. Approximately 6 qt (5.7 l) capacity.
The rear axle is mchanically driven from the front axle by a universal shaft. The axle has
a be-directional overrunning clutch in the rear driveshaft. When lubricating the rear axle,
use SAE 80W-90 gear lube, API GL-5. Lubricant capacity is 2.9 liter (3.1 qt.)
Mechanical drum-type. Individually controlled by two pedals connected by cable and
conduit for steering assist. Pedals may be latched together for two wheel braking. Lever
provided for parking brake.
Front Tires—23 x 8.50-12, Rear Tires—16 x 6.50-8. All tires: 4-ply rating, tubeless type.
Pressure—20 psi (138 kPa).
0–16 kmh forward and reverse.
Frame is welded, formed steel.
Fuel gauge, water temperature gauge, hour meter and warning lights for high temperature
shutdown, oil pressure, amperage and glow plug are mounted on the console.
Throttle, power take-off switch, parking brake, implement lift, implement lift lock,
ignition switch and high temperature override switch are all hand-operated.
Forward/reverse traction pedal and turning brakes are foot-operated.
12