Setting Down, Transportation And Storage; Maintenance - Miele HS10 Operating Instructions Manual

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 25
en
When vacuuming fine dust, e.g.
sawdust, sand, plaster, flour, talcum
powder etc., electrostatic charges
build up naturally. Under certain con-
ditions these charges will be re-
leased. To avoid the unpleasant ef-
fects of these discharges, a metal in-
lay has been incorporated into the
underside of the handle. Please
make sure that you keep your hand
in constant contact with this metal
strip during vacuuming (dia. 24).
Setting down, transportation
and storage
Park system for pauses during vacu-
uming (dia. 25)
The Park system allows you to conveni-
ently park the suction tube and floor-
head during pauses.
 Slot the floorhead into the parking at-
tachment at the back of the vacuum
cleaner.
If your vacuum cleaner is on a slop-
ing surface, e.g. a ramp,
- retract the telescopic tube fully
- do not use the park system if your
vacuum cleaner has an EasyLock
suction tube.
Park system for storage (dia. 26 + 27)
Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
38
If your vacuum cleaner has an Easy-
Lock suction tube you can separate
the two sections for storage purposes.
 Press the release button on the lower
section and pull the top section out.
 Push the connection piece attached
to the upper tube into the lower tube.
 Stand the vacuum cleaner upright.
If your vacuum cleaner has a tele-
scopic tube, retract the tubes fully so
that it takes up less room for storage.
 Slot the floorhead downwards into
one of the parking attachments on
the sides of the vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.

Maintenance

Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and un-
plug it.
The Miele filtration system consists of
three components:
– Dustbag
– Dust compartment filter (for motor
protection)
– Exhaust filter
These will need to be replaced from
time to time to ensure that your vacuum
cleaner performs efficiently.

Advertisement

Table of Contents
loading

Table of Contents