Installing The Chassis Into The Rack; Installing The Chassis Into A Telco Rack - Bosch DIP-7080-00N Installation Manual

28 en | Rack installation
Locking Tabs
Both chassis rails have a locking tab, which serves two functions. The first is to lock the
system into place when installed and pushed fully into the rack, which is its normal position.
Secondly, these tabs also lock the system in place when fully extended from the rack. This
prevents the system from coming completely out of the rack when you pull it out for servicing.
4.3.4

Installing the chassis into the rack

To install the chassis into a rack:
1.
2.
3.
4.
Warning!
!
Do not pick up the unit with the front handles. The handles are designed to pull the system
from a rack only.
Warning!
Stability hazard
!
Before sliding the unit out for servicing make sure that the rack stabilizing mechanism is in
place, or the rack is bolted to the floor. Failure to stabilize the rack can cause the rack to tip
over.
See also:
Rack precautions, page 24
4.3.5

Installing the chassis into a Telco rack

To install the chassis into a Telco type rack, use two L-shaped brackets on either side of the
chassis (four in total). First, determine how far the chassis will extend out the front of the
rack. Larger chassis should be positioned to balance the weight between front and back. If a
bezel is included on the chassis, remove it. Then attach the two front brackets to each side of
2014.12 | V4 | DOC
Extend the outer rails as illustrated above.
Align the inner rails of the chassis with the outer rails on the rack.
Slide the inner rails into the outer rails, keeping the pressure even on both sides. When
the chassis has been pushed completely into the rack, it should click into the locked
position.
Optional screws may be used to secure the to hold the front of the chassis to the rack.
Installation Manual
DIVAR IP 7000 2U
Bosch Sicherheitssysteme GmbH