Table of Contents
Advertisement
f After capturing the image, the [Logo select] is set to [User]. The captured image will be displayed when the projector
start-up next time.
Note
f Only supports still image-based computer (RGB) and still image-based HDMI signals input.
f Capture may not be available depending on the input signal.
f It is recommended to capture the same resolution signal as the display dots (panel resolution) of the projector.
For PT-TW340, PT-TW250 : 1 280 x 800
For PT-TX400, PT-TX310 PT-TX210 : 1 024 x 768
f [Capture] and [Logo select] will be unavailable when [Logo PIN code lock] is set to [On].
f The adjustments of the [Keystone] will be canceled temporarily when the image is capturing.
[Logo PIN code lock]
Set the Logo PIN code (three-digit).
Press as to select [Logo].
1)
2)
Press the <ENTER> button.
f The [Logo] screen is displayed.
Press as to select [Logo PIN code lock].
3)
4)
Press the <ENTER> button.
f The [Logo PIN code] input screen is displayed.
5)
Press the <ENTER> button.
6)
Enter the Logo PIN code you have set according to the steps in "Enter a Logo PIN code".
r Enter a Logo PIN code
i) Press as to select a number from 0 to 9.
ii) Press the <ENTER> button.
f The fixed number change to , the cursor move to the next digit.
iii) Repeat the above steps, and enter a three-digit number.
f Move the cursor to [Set] after fixing the three-digit number.
iv) Press the <ENTER> button.
f Return to the [Logo] screen.
Press as to switch the item.
7)
f The items will switch each time you press the button.
[On]
[Off]
Attention
f The initial Logo PIN code is "111".
f Change the Logo PIN code periodically that is hard to guess.
Note
f If you want to correct the digit, press the <MENU> button to reset the digit and then re-enter it.
f Press the <ENTER> button after moving the cursor to [Cancel] to reset the all digits.
f If you entered an incorrect digit, the digit () will turn red and reset, and then re-enter a digit.
[Logo PIN code change]
Change the Logo PIN code.
Press as to select [Logo].
1)
2)
Press the <ENTER> button.
f The [Logo] screen is displayed.
Press as to select [Logo PIN code change].
3)
4)
Press the <ENTER> button.
f The [Logo PIN code] input screen is displayed.
Chapter 4 Settings - [Expand] menu
Set or change [Logo select] and [Capture] are disabled without entering the PIN code.
Set or change [Logo select] and [Capture] are enabled without the PIN code.
ENGLISH - 65
Advertisement
Table of Contents
