1.0
Introduction
This chapter provides an overview of the Customer Programming Software (CPS) and tuner program
which are designed for use in a Windows 95/98 environment. These programs are available in
separate kits as listed in the Table 5-1. An Installation instruction manual is also included with each kit.
Refer to the appropriate program on-line help files for the programming procedures.
NOTE
EMEA CD
Installation Card
2.0
Global Radio Tuning Setup
A personal computer (PC) using Windows 95/98 and a global tuner program are required to tune the
radio. To perform the tuning procedures, the radio must be connected to the PC, radio interface box
(RIB), and test equipment shown in Figure 5-1.
Battery
Eliminator
7.5V Reg.
RLN4510 (GP320/340/360/380)
JMKN4125_ (GP344/388)
+12VDC
Power
Supply
Battery Block
0180305G54
RADIO TUNING AND PROGRAMMING
Table 5-1 Software Installation Kits Radio Tuning Setup
Description
RF Adaptor
HLN9756
3.5 mm to
Ferrule BNC
Radio
20 dB Pad
10 dB (GP344/388)
Program / Test Cable
RKN 4074 (GP320/340/360/380)
JMKN 4123 (GP344/388)
AC Plug
120/230 Vac
RIB Power Supply
Figure 5-1 Radio Tuning Test Equipment Setup
68P64113B14_
T ransmit
Receive
Audio In
Test Box
RLN4460
DB15
DB9
RIB
RLN-4008
Computer Interface
Cable 3080369B72
Chapter 5
Kit Number
ENLN4115_
Service Monitor
or Counter
Wattmeter
RF Generator
Tx
Audio Generator
Rx
Sinad Meter
AC Voltmeter
Tx Data
Rx
Data
Gnd