Table of Contents
Advertisement
Connections
3.
Straighten a supplied speaker wire to the gravity direction and
put in the hole on the centre of Stand Base.
4.
Connect the upper Speaker to the assembled Stand.
5.
Insert a screw clockwise into the hole on the rear of the speaker
using a screwdriver.
And then connect a speaker cable.
6.
This is the appearance after the speaker is installed.
Follow this steps to install other speaker.
* HT-F5550HK only - Front/Surround Speakers
1.
Turn the Stand Base upside-down and connect it to the Speaker.
2.
Use the driver to combine the screws on the 3 marked holes.
Installing a speaker is finished. Follow the same steps to install
other speakers.
3.
If you want to adjust the height of the speaker, loosen a screw
on the rear of the speaker base first.
4.
Pull up the speaker in the arrow direction. (Be careful as an
excessive force may result in a physical damage.)
5.
Fit the speaker in a height adjusting a hole, and then use a screw
to fasten a speaker.
6.
This is appearance of after the speaker is installed and height
adjusted. To adjust height of other speakers, follow the step 3 ~ 5.
16
|
English
3
4
Speaker
Stand
5
6
Stand Base
1
2
Speaker
3
4
5
6
or
Advertisement
Table of Contents
