Advertisement
Removing the DVD mechanism assembly
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from the connector J14 and
J21 on the DVD MPEG board.
2.
Remove the two screws E attaching the DVD
mechanism assembly and pull up with drawing out.
3.
Disconnect the harness from the connector J2 on the
DVD loader board.
Removing the rear panel (See Fig.7 and 8)
Prior to performing the following procedure, remove
the top cover and power cord.
1.
Disconnect the harness from the connector NW11 on
the DSP board.
2.
Remove the two screws F, four screws G, and five
screws I attaching the each boards to the rear panel.
3.
Remove the three screws J attaching the rear panel
on the back of the body.
Removing the tuner pack (See Fig.7 and 8)
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from the connector CON01
on the tuner pack.
2.
Remove the two screws F attaching the tuner pack
to the rear panel.
Removing the jack board (See Fig.7 and 8)
Prior to performing the following procedure, remove
the top cover.
1.
Disconnect the card wire from the connector VW2 on
the jack board.
2.
Remove the four screws G attaching the jack board
to the rear panel.
3.
Disconnect the connector VW1 on the jack board
and pull up the jack board.
Removing the fan motor (See Fig.7 and 8)
Prior to performing the following procedures, remove
the top cover .
1.
Disconnect the harness from the connector NW11 on
the DSP board .
2.
Removing the two screws H attaching the fan motor
on the rear panel.
(See Fig.5 and 6)
Rear panel
DVD mechanism assembly
Rear panel
J2
Fig.6
H
Fan motor
J
I
Fig.7
DSP board
VW1
NW11
(on the
DSP board)
Fig.8
TH-A5R
DVD
MPEG
board
J14
E
J21
Fig.5
DVD mechanism
assembly
DVD loader board
Rear panel
G
F
J
J
CON01
VW2
Jack
Tuner pack
board
1-7
Advertisement
