Table of Contents
Advertisement
Displaying the picture
Activate your signal source. Turn the signal
1.
source on, and make it send the signal to
the projector.
2.
Use the VOLUME + / VOLUME - buttons
to adjust the volume.
To have the projector silent, press the MUTE
button on the remote control.
3.
Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from the
HDMI, COMPONENT (Y, Cb/Pb, Cr/Pr),
S-VIDEO or VIDEO port, or the COMPUTER
button for selecting an input signal from the
COMPUTER IN1, COMPUTER IN2, LAN,
USB TYPE A or USB TYPE B port.
4.
Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
5.
Use the zoom ring to adjust the screen
size.
6.
Use the focus ring to focus the picture.
CAUTION
on, use one of methods below.
- Use the supplied lens cover.
Taking any other action may cause the damage on the projector.
NOTE
The ASPECT button does not work when no proper signal is inputted.
17, 19)
(
MY SOURCE/
VIDEO
COMPUTER
DOC.CAMERA
ASPECT
AUTO
SEARCH
BLANK
MAGNIFY
FREEZE
PAGE
VOLUME
UP
VOLUME+ button
ON
DOWN
VOLUME- button
OFF
KEYSTONE
MY BUTTON
MUTE
1
2
MUTE button
POSITION
MENU
ENTER
RESET
ESC
INPUT button
VIDEO button
MY SOURCE/
VIDEO
COMPUTER
DOC.CAMERA
COMPUTER button
ASPECT
AUTO
SEARCH
BLANK
FREEZE
PAGE
VOLUME
MAGNIFY
UP
ON
ASPECT button
DOWN
OFF
KEYSTONE
MY BUTTON
MUTE
1
2
MENU
POSITION
ENTER
ESC
RESET
Zoom ring
11
Advertisement
Table of Contents
