Table of Contents
Advertisement
11. Programmable Features
11.2.2 Cordless handset setup
Alarm
An alarm sounds at the set time for 3 minutes once or
daily. Alarm can be set for each cordless handset.
Important:
R Set the date and time beforehand (feature #101 on
page 28).
1. MMENUN (soft key) A M#NM7NM2NM0N
2. Select the desired alarm option. A MSELECTN (soft
key)
"Off"
Turns alarm OFF. Go to step 6.
"Once"
An alarm sounds once at the set time.
"Daily"
An alarm sounds daily at the set time. Go to step
4.
3. Enter the desired month and date. A MOKN (soft
key)
4. Set the desired time.
R Press MAM/PMN (soft key) repeatedly to select
"AM" or "PM". A MOKN (soft key)
R If you select French for the language (feature
#110 on page 102), the time is set using a 24
hour clock.
5. Select the desired alarm tone. A MSELECTN (soft
key)
R We recommend selecting a different ringer tone
from the one used for outside calls.
6. MSELECTN (soft key) A MOFFN
R When the alarm is set,
Note:
R To stop the alarm, press MOFFN or place the cordless
handset on the charger.
R When the cordless handset is in use, the alarm will
not sound until the cordless handset is in standby
mode.
Display language
Important:
R When you install the batteries for the first time,
the cordless handset may prompt you to set
display language and date and time.
1. Perform step 2 in "Display language",
page 102, and then press MSELECTN (soft key).
2. Continue from step 2 in "2.10.2 With the
cordless handset (KX-MB2060 optional)",
page 28.
You can select either "English" or "Français" as the
display language. The default setting is "English".
1. MMENUN (soft key) A M#NM1NM1NM0N
102
is displayed.
2. Select your desired language. A MSAVEN (soft
key)
3. MOFFN
Changing the cordless handset name
Each cordless handset can be given a customized name
("Bob", "Kitchen", etc.). This is useful when you make
intercom calls between cordless handsets. You can also
select whether or not the cordless handset name is
displayed in standby mode. The default setting is "No".
If you select "Yes" without entering any cordless
handset name, "Handset 1" to "Handset 6" is
displayed.
1. MMENUN (soft key) A M#NM1NM0NM4N
2. Enter the desired name, up to 10 characters (see
page 105 for character entry).
R If not required, go to step 3.
3. MSAVEN (soft key)
4. Press MCN or MDN repeatedly to display the desired
setting.
5. Press MSELECTN (soft key) 2 times.
6. MOFFN
Advertisement
Table of Contents
