Important Safety Information - Haier HMS1460B User Manual

20
MAINTENANCE

IMPORTANT SAFETY INFORMATION

Do not use a multiple socket extension cord. A separate earthed socket is required which shall be accessible at all times.
If the cord becomes damaged, it should be replaced by the manufacturer, its service agent or similarly qualifi ed person.
Never remove the plug from the socket by pulling on the cord, always grasp the plug.
The door may get hot during use, keep children away whilst the machine is operating.
Never open the detergent drawer while the machine is running.
When installing the product, make sure the mains cord is not trapped or twisted.
WARNINGS:
THIS APPLIANCE IS INTENDED FOR DOMESTIC USE ONLY, COMMERCIAL OR ANY OTHER
USE MAY INVALIDATE THE WARRANTY AND MIGHT BE DANGEROUS.
Never touch or operate the machine with wet hands or when bare footed.
Do not put the machine on a carpet that can block the ventilation slots on the bottom of the unit.
Do not install this machine outdoors or in a damp place.
Do not install this product near a heat source or in direct sunlight.
Do not place any object on the machine when it is operating.
Caution
To prevent electric shock disconnect from
the main before removing the cover
Warning: This appliance must be earthed.
The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin socket, suitably earthed and should be
protected by a 13 amp fuse in the plug.
The appliance is supplied with a standard 13 amp 3-pin plug fi tted with a 13-amp fuse. Should the fuse require replacement, it must be
replaced with a fuse rated at 13 amps and approved to BS1362.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other reason,then the cut off plug should be
disposed of safely, do not insert the cut off plug into a mains outlet to prevent the hazard of electric shock. Remove the fuse before
disposal.
There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet.
How to wire a 13 amp plug. (UK Only)
The wires in the mains lead on this appliance are coloured in accordance with the following code:
Green and Yellow - Earth Blue – Neutral Brown – Live
As the colours may not correspond with the markings identifying the terminals in your plug proceed as follows.
The green and yellow wire must be connected to the terminal in the plug which is marked with the
letter E or with the earth symbol or coloured green and yellow.
The blue wire must be connected to the terminal marked N.
The brown wire must be connected to the terminal marked L.
You must make sure the lead is fi rmly secured under the cord clamp.
WATER CONNECTION
The product should be connected to the water main using new hose sets, old hose sets should not be reused.
The water pressure must not be less than 0.03MPa.