Ani; Cli - Samsung OfficeServ 100 Series User Manual

NO CID DSP
NOTE: The Caller ID features may require optional software and/or hardware.
Please see your service and installation company for details.
WHAT IS ANI?
[T1/E&M NOT SUPPORTED ON THE OS 7030, OS 7100 and OS 7200-S]
ANI (Automatic Number Identification) is a feature offered by some telephone
service providers that provides the calling party's telephone number. This service
is only available on E&M Tie Lines on a T1, digital trunk. ANI is similar to Caller
Identification (CID) but the format and information of the calling person is differ-
ent. CID uses FSK signalling and ANI uses DTMF signalling. Usually, with ANI, a call-
ing party's identity is the Listed Directory Number (LDN) unless a separate bill-to-
number has been specified, (in which case the bill-to-number will be sent). Note
that ANI does not provide calling party NAME, only the number.The phone system
can provide calling number to name translation table.
WHAT IS CLI?
On ISDN circuits, calling party information is called CLI and is supported on both
BRI (not supported in the US) and PRI type circuits on the OS 100 and on the OS
500 systems (not supported on OS 7030). On BRI circuits the OS 100 and the OS
500 only support number delivery and, like ANI, a name can be attached to the
telephone number of frequent callers via the Caller ID translation table. On 5ESS
and NI2 PRI circuits both name and number support is provided on the OfficeServ
100, OfficeServ 500, and OfficeServ 7000 Series systems.
SELECTING YOUR CALLER ID DISPLAY
Simulteneous display of Caller ID name and number on incoming CO calls on both
lines of display keysets is supported on all OfficeServ systems, on transferred CO
calls, you can decide if you want to see the Caller ID name or Caller ID number in
the first line of the display. Regardless of which data is selected, you can press the
NND key to view the other pieces of Caller ID information. To select the type of
Caller ID information you wish to view:
• With the handset on-hook, press TRSF and then dial 119.
• To set the first line of a ringing call display dial 0.
• To set the second line of a ringing call display dial 1.
Set the data to display from the following:
- To show nothing dial 0.
56
Caller ID Digital Signal Processors (CIDDSP's) are resources
in the OfficeServ 100, the OfficeServ 500, and OfficeServ
7000 Series systems required for receiving CID data. If there
are no CIDDSP's available at the time a call comes in, this is
the message you will see on your display.