Brother MFC-J4335DW Quick Setup Manual

Quick Setup Guide
Read the Product Safety Guide first, then read this Quick Setup Guide for the correct installation procedure.
MFC-J4335DW
MFC-J4345DW
MFC-J4535DW
EN FR
1
Unpack the machine and check the components
Remove the protective tape or film covering the machine and the supplies. The components included in the box may differ depending on your country.
* Most of the illustrations in this Quick Setup Guide show the MFC-J4535DW.
2
Load plain Letter paper in the paper tray
Pull the paper tray
completely out of the
machine.
Connect the
3
power cord
NOTE
You can adjust the control panel angle
to read the LCD more easily.
6
Check the print quality
Follow the LCD instructions, Follow the LCD instructions to
and then press the [OK] or c. check the quality of the four color
The machine prints the Print blocks on the sheet, and then
Quality Check Sheet. start the cleaning procedure.
Video setup instructions:
support.brother.com/videos
Fan the paper well and load it
in the tray.
4
Install the starter ink cartridges
Open the ink cartridge
cover.
OK Poor
The latest manuals are available at the Brother support website:
support.brother.com/manuals
Manuals in Spanish for this model are available at support.brother.com.
Manuales en Español para este modelo están disponibles en support.brother.com.
NOTE
• Save all packing materials and the box in case you must ship your machine.
• You must purchase the correct interface cable for the interface you want to use.
USB cable
Use a USB 2.0 cable (Type A/B) that is no more than 6 feet (2 meters) long.
Ethernet (Network) cable (MFC-J4535DW only)
Use a straight-through Category 5 (or greater) twisted-pair cable for 10BASE-T or 100BASE-TX
Fast Ethernet Network.
For more information about paper handling and sizes, see the Online
User's Guide at support.brother.com/manuals.
Adjust the paper guides.
Follow the LCD instructions
to install the ink cartridges.
Close the ink cartridge
cover. The machine will
prepare the ink tube
system for printing.
NOTE
Quickly shake just the
The first time you install the
black ink cartridge
ink cartridges, the machine
horizontally 15 times as
will use extra ink to fill the
shown, before inserting
ink delivery tubes. This is a
it into the machine.
one-time process that enables
high-quality printing.
Adjust the print alignment (recommended)
7
To adjust the print alignment before using your machine, press [Start] or c.
Follow the LCD instructions
to print the Adjustment Sheet.
The black circle mark is
located in the upper left corner
of the sheet.
Slowly push the paper tray
Pull out the paper support a,
completely into the machine. and unfold the paper support
flap b so that the printed
pages do not fall.
5
Follow the LCD instructions to set
the date and time.
After setting the date and time,
you can set the Firmware Update
defaults.
Place the Adjustment Sheet
face down on the scanner
glass.
Make sure the black circle
mark is in the upper left corner
of the scanner glass.
D01R2A001-00
USA/CAN
Version 0
2
1
Set the date and
time
Follow the LCD
instructions and
complete adjusting the
alignment.
When finished, remove
the Adjustment Sheet
from the scanner glass.