Epson Stylus Pro 4000 Limited Warranty page 7

Repackaging and Transportation Instructions: To avoid permanently damaging the
printer, it is extremely important that you follow the instructions below when preparing to
ship or transport the printer. (Please refer also to the additional instructions in your Printer
Guide.)
NOTES:
• In case shipment of the printer for service becomes necessary, to prevent un-repairable
damage to the printer, the printer should be packaged in its original box and packaging
materials and secured to a pallet. If you do not have these items, you must contact Epson
and Epson will supply appropriate items for your shipment.
• To prevent ink from spilling and damaging the printer during shipping or other transport,
the printer must be shipped or transported with 110 ml ink cartridges installed. The printer
is equipped with a valve system that closes and seals all ink supply lines. In order for this
valve system to properly close, the 110 ml ink cartridges must be installed and the ink lever
secured in the locked (up) position. Empty cartridges can be used for transportation
purposes.
• Have at least two people lift the printer when packaging or transporting it.
INSTRUCTIONS:
1) Turn on the printer.
2) Remove any paper or other media in the printer. Remove the roll paper spindle and
paper tray.
3) Make sure that 110 ml ink cartridges are installed in the printer. If you are using 220 ml
cartridges, remove them and install 110 ml cartridges.
If you have the original 110 ml cartridges that came with the printer (even if they are
Note:
empty), install them before shipping the printer. To store any partially-used cartridges that
you take out before shipment, tape over the needle valve hole until you are ready to use
the cartridges again.