How to use ..........12 Troubleshooting ........22 Specifications ........23 Select air temperature ......14 Installing or removing the nozzle ..17 Thank you for purchasing this Panasonic product. Before operating this unit, please read these instructions completely and save them for future use.
Panasonic Corporation. WARNING A nanoe™ is a nano-sized ion particle coated with water particles. ►Plug and cord Do not use the appliance when Safety precautions the cord is tied. - Doing so may cause electric...
Page 5
• The interior gets red, and smoke comes out. accumulating. - Immediately contact a service center authorized - Failure to do so may cause fire due to insulation by Panasonic. failure caused by humidity. Disconnect the plug ►Maintenance and wipe with a dry cloth.
Page 6
Contact a service center authorized by - Doing so may cause electric shock or fire. Panasonic for repair when necessary. Do not store within the reach of children or infants. Do not allow children or infants to use it.
Page 7
WARNING CAUTION ►To protect your hair For additional protection, the installation of a residual current device (RCD) having a Do not use the appliance when the air inlet is rated residual operating current not exceeding damaged. 30 mA RCD is advisable in the electrical circuit - Doing so may damage your hair due to drawn supplying the bathroom.
Page 8
Do not look into the air outlet during CAUTION operation. ►Precautions - The blown air may carry dust or other foreign objects, which may cause injury. Do not drop or subject to shock. - Doing so may cause electric shock or ignition. When switching to the other nozzles, be Intended for drying your hair and making aware of the nozzle temperature.
Parts identification and functions Mineral ion outlet LENGTH switching nanoe™ outlet button nanoe™ lamp Handle Lamp indication area Ring for hanging Cord VOLUME: Plug 1 DOWN Power switch Back 2 UP Ⅲ ..... Turbo LENGTH: Ⅱ ....Dry 3 SHORT Ⅰ...
About nanoe™ and double mineral* What is nanoe™, mineral ion? * “Double mineral” means mineral ions generated by two (nanoe™, mineral ion generation method: high voltage zinc electrodes. discharge) nanoe™ nanoe™ and double mineral effect nanoe™ is generated by collecting the available Controls waviness by balancing hair nanoe™...
By doing this, nanoe™ can continue to penetrate the Quick steps for using hair, supplying moisture and moisturizing the hair thoroughly right up to the tip. 1. Plug into the household outlet ►Note Results of nanoe™, mineral ions and hot/cold alternating mode (see page 16) on hair vary according to the individual, and the following people may find it 2.
Press to select the styling effect, and How to use press to select the hair length. Before drying with the hair dryer, use a towel to gently wipe away the water, and comb the tangled hair with a ►To select styling effect comb or your hands.
Page 13
SHORT LONG Light on Turn on the power switch and select a Short hair with Middle-long hair Long hair with Approx. wind strength. the ends cannot with the ends the ends 5 cm hair or more below touch the positioned length Ⅲ...
• After blow-drying your hair to 90 % dry, use the hot/ ►Notice cold alternating mode to set the hairstyle and make Styling and treatment agents etc. can be used. However, if you use sticky substances such as oil, gel or your hair shiny and smooth.
Page 15
Air temperature type Intelligent temperature control mode (to reduce hot sensation of the hot air) level level In cases such as after bathing in summer, when you feel Hot air mode Hot air mode uncomfortable to hot air due to the hot weather, you can Hot air is Press and Hot air is blown out.
Page 16
• Set the power switch to [ ], and the hair dryer will 3. Run your hand through your hair from the top of your head to hair ends while switch to HOT mode. blowing air on hair (single side). <Image of room temperature and hot air temperature>...
Hair tip care mode Installing or removing the nozzle (to moisturize and smoothen hair ends) To install 1. Set the power switch to [ Ⅰ ] level. • Align the nozzle with the air outlet of the appliance to 2. Press to switch to , and then CARE lamp will install it.
Making a drooping and smooth How to use the diffuser hairstyle Making a fluffy hairstyle To comb and tidy your hair, use the comb on the diffuser to comb the hair To make a fluffy hairline Install the diffuser onto the hair dryer. Move the hair from roots to tips.
To set your hair Tips on usage 1. Dampen the area of your hair you To decrease hair volume want to set with water. • Grab and rub your hair with your Run your hand through your hair in the same direction as the hair flow, hands, so that water can and apply hot air from top to bottom.
Do this about once a month or over Maintenance of the hair dryer Maintenance of the air inlet nanoe™ outlet Air inlet Remove dust and hair etc. from the surface and Mineral ion outlet inside Wipe to clean dust or hair If dust is attached to the Air outlet TEMP...
Page 21
►Note Do this when dirty • When performing maintenance, do not block the air inlet with your hand. Maintaining the main body • Dust will disperse during or after cleaning. Before using the hair dryer, be sure to check that there is no Soak a cloth in the soapy water Cloth and squeeze it out firmly, then...
HOT lamp is blinking quickly (twice per Please consult an Device abnormality. authorized service center. second). If the problems still cannot be solved, contact a service center authorized by Panasonic.
Specifications Product name Hair Dryer Product model EH-XD20 Power source / 220 V〜 50 Hz rated frequency 1 800 W (when using [ Ⅲ ] level Power consumption and HOT mode) This product is intended for household use only.