How To Clean; Before Requesting Repair - Panasonic EH-TSW5E Operating Instructions Manual

Eye warming massager
Table of Contents

Advertisement

Available languages
  • EN

Available languages

How to Clean

Clean when you feel cleaning is necessary.
Cleaning the main unit
Wipe away dirt using a cloth that has been
moistened in water containing dissolved bar soap.
Do not use alcohol, paint thinner, benzine, or nail polish remover.
Using these may damage the appliance or cause cracks or discoloration
in the components.
Cleaning the water supply plate, silicon pad, and nose pad
# Remove from
$ Wash with
the main unit.
water.
How to attach the silicon pad and nose pad
Push the 7 clasps on the silicon pad and 2 clasps on the nose pad in the
direction of the arrows all the way into the corresponding slots on the main unit.
Position of the clasps
EN17
% Wipe with a
& Reattach to
dry cloth.
the main unit.
Position of the clasps

Before Requesting Repair

Before calling a service supplier, please check the following possible causes.
Symptom
Possible cause
The main unit and AC
adaptor are connected to a
household outlet.
It is not charged.
The appliance does
(The battery is empty.)
not operate even
when the power/
Cannot be used while
temperature switch
charging.
is pressed.
The power/temperature
switch is not firmly
pressed.
The appliance is fully
charged. This does not
indicate a problem.
(P. EN11)
The charging
The adaptor is not properly
indicator lamp does
inserted into the household
not go on/goes out.
outlet.
The appliance plug is not
firmly inserted into the
appliance socket.
The appliance can
be used only for a
The life of the battery
few minutes even
(approximately 3 years)
after charging it.
The adaptor is
It is loosely inserted into
abnormally hot.
the household outlet.
No steam comes out
The water supply plate is
from the appliance after
not wet.
a few minutes after
pressing the power/
The water supply plate is
temperature switch.
not firmly attached.
Steam is invisible.
Remedy
Remove the AC adaptor
from the main unit.
Recharge using the AC
adaptor. (P. EN11)
Remove the appliance plug
and use it.
(P. EN12)
Press the power/temperature
switch firmly until it goes all
the way down.
Properly insert the adaptor
into the household outlet.
Firmly insert the appliance
plug into the appliance
socket.
Please contact an authorized
service center (as described
in the warranty).
(Do not change the battery
yourself. Doing so may
damage the appliance.)
Use a household outlet that
is not loose.
Wet the water supply plate.
(P. EN12)
Firmly attach it. (P. EN13)
EN18

Advertisement

Table of Contents
loading

Table of Contents