Panasonic AVC ULTRA AJ-UPX36OED Operating Instructions Manual page 89

[ON]
[OFF]
[DURING PEAKING]
(Factory setting: [OFF])
[DETAIL]
Sets the intensity of the contour for the video to make it easier to focus.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [ON])
[DETAIL LEVEL]
Sets the intensity of the contours.
The items that can be set are as follows.
f [−3]...[3]
(Factory setting: [0])
[DETAIL FREQ.]
Adjusts the frequency of the contour highlights.
The items that can be set are as follows.
f [HIGH], [LOW]
(Factory setting: [LOW])
[EI ASSIST]
[ZEBRA]
Sets whether to superimpose the zebra signal to the output.
[MOMENT]
[ON]
[OFF]
(Factory setting: [OFF])
[ZEBRA1 DETECT]
Sets the detection level of zebra pattern 1.
The items that can be set are as follows.
f [0%]...[109%]
(Factory setting: [80%])
[ZEBRA2 DETECT]
Sets the detection level of zebra pattern 2.
The items that can be set are as follows.
f [0%]...[109%]
(Factory setting: [100%])
[ZEBRA2]
Enables/disables zebra pattern 2 and selects [SPOT].
The items that can be set are as follows.
f [ON], [SPOT], [OFF]
(Factory setting: [OFF])
[WFM MODE]
Sets the display of the waveform monitor. Displaying of the waveform and the vector can be switched.
[WAVE]
[VECTOR]
[WAVE/VECTOR]
(Factory setting: [WAVE])
[WFM TRANSPARENCE]
Sets the transmittance of the waveform monitor.
The items that can be set are as follows.
f [0%], [25%], [50%]
(Factory setting: [25%])
Chapter 4 Operation — Menu settings
Enables the monochrome display.
Disables the monochrome display.
Enables the monochrome display while the peaking display is enabled.
Press the USER button to which [ZEBRA] is assigned or touch the USER button icon to superimpose the zebra signal for
approximately five seconds.
Always superimposes the zebra signal. Press the USER button to which [ZEBRA] is assigned in the [ON] settings or touch
the USER button icon to set to [OFF].
Does not superimpose the zebra signal. Press the USER button to which [ZEBRA] is assigned in the [OFF] settings or touch
the USER button icon to set to [ON].
Displays the waveform.
Displays the vector.
Displays the waveform and the vector.
The waveform, vector or no display toggles in order each time the USER button to which [WFM] is assigned is pressed or the
USER button icon is touched.
– 89 –