Automatic Safety Cut-Out; Wipe Protection; Switching On; Switching Off - Siemens ET475FUB1E Instruction Manual

Automatic safety cut-out

en
bAutomatic safety cut-out
If an appliance has been switched on for a long time
c u t - o u t A u t o m a t i c s a f e t y
without the setting being changed, the automatic switch-
off is activated.
The appliance stops heating.
indicator / flash alternately on the display.
• œ
The indicator goes out when you touch any of the
controls. You can implement new settings.
At what point the automatic switch-off is activated
depends on the grill setting selected (2 to 4 hours).
kWipe protection
If you wipe over the control panel while the appliance is
W i p e p r o t e c t i o n
switched on, settings may be altered.
To prevent this from happening, your appliance has a
wipe protection function.

Switching on

Touch the „ symbol when the appliance is switched on.
An audible signal sounds. The
The control panel is locked for 30 seconds. You can
now wipe over the control panel without altering any
settings.
The main switch is excluded from the wipe
Note:
protection function. You can switch off the appliance at
any time.

Switching off

Touch the symbol.
„
The wipe protection function is switched off.
26
" ‰ and the residual heat
indicator lights up.
Ñ
[Energy consumption
indicator
You can use this function to display the total energy
n i n d i c a t o r E n e r g y c o n s u m p t i o
consumption between switching the appliance on and
off.
Once switched off, the energy consumption in kilowatt
hours (e.g. 1.87 kWh) is displayed for 10 seconds.
The accuracy of the display depends, amongst other
things, on the voltage quality of the power supply.
The energy consumption display may not be
activated.~ "Basic settings" on page 27