Advertisement
7. Vertical transport de-curler
[Process]
Use the vertical transport de-curler adjustment jig to adjust the nip
quantity.
1)
Insert the marked section of the jig corresponding to each nip
quantity under the unit as shown below.
2) Insert the vertical transport de-curler adjustment jig until it makes
contact with the shaft.
3) Adjust with the set screw, and tighten the screw (S tight M3).
Perform the same procedures for F and R.
Check that the transport de-curler adjustment jig is smoothly inserted
on either side of F/R.
If the jig cannot be inserted smoothly, perform the adjustment and
check again.
Nip quantity (reference)
dimension between shafts
Inch series
EX AB series
Japan
Transport de-curler adjustment jig
M3
Insert Set screw
M3
Set screw
1.0 (5.0)
Set screw
Insert
6 – 5
AR-FN3
8/19/1999
Advertisement
