2. Carefully place the device on the front panel (interfaces pointing to you), and insert the
mounting seal into the stainless steel front panel as shown. Also pay attention to numbers
④ - ⑥.
④
Seal corner is underneath the housing frame.
⑤
The coding tap is flush on the provided cutout.
⑥
Positioning hook of the seal engages completely in cutout, flush and without overhang.
Similar to figure
3. Check the correct fit of the mounting seal:
– The coding tap is placed at the specified location.
– All positioning hooks rest flush in their cutouts. The mounting seal is installed correctly
– The edge of the mounting seal is flush with the edge of the stainless steel front all
See also
Accessories (Page 9)
IFP2200 INOX MT ETH
Compact Operating Instructions, 07/2021, A5E42185570-AD
when it lies flat on the entire stainless steel front. There must be no distortions or
overhangs as shown in the picture detail.
If necessary, adjust the seat: To do this, press the mounting seal into the cutout at the
marked points.
around.
Installing and connecting the device
3.2 Inserting the mounting seal
21