Adjusting Grinder Settings; Handling The Brew Group - Philips EP5065 User Manual

Note: To set the volume of coffee, cappuccino and latte macchiato, follow the same procedure: press
and hold the button of the beverage and press the OK button when the cup contains the desired
amount. To adjust the volume of other drinks: select your drink, press and hold the OK button until the
display shows the MEMO icon and then press the OK button again to save the desired volume. To
adjust the volume of milk-based coffee beverages, first insert the milk carafe and save the milk
volume and then save the coffee volume.
Adjusting coffee strength
- To change the coffee strength, press the AROMA STRENGTH button.
- Each time you press the AROMA STRENGTH button, the machine selects a higher aroma strength
setting. There are 5 strengths, 1 is very mild and 5 is very strong. After setting 5, setting 1 is selected
again (Fig. 19).
- Note: You can also use the AROMA STRENGTH button to brew coffee with pre-ground coffee
- The display shows the chosen strength. After adjusting the coffee strength, the display shows the
main menu again and saves the chosen aroma strength when you brew a coffee.

Adjusting grinder settings

You can adjust the grinder settings by using the grind setting knob inside the bean container. There
are 5 different grind settings you can choose from. The lower the setting, the stronger the coffee.
Note: You can only adjust the grind settings when the machine is grinding coffee beans. You need to
brew 2 to 3 drinks before you can taste the full difference.
Caution: Do not turn the grind setting knob more than one notch at a time to prevent damage to the
grinder.
1 Place a cup under the coffee dispensing spout.
2 Open the lid of the bean hopper.
3 Press the ESPRESSO button.
4 When the grinder starts grinding, press down the grind setting knob and turn it to the left or right
(Fig. 20).

Handling the brew group

Go to www.philips.com/coffee-care for detailed video instructions on how to remove, insert and
clean the brew group.
Removing the brew group from the machine
1 Switch off the machine by pressing the main switch on the back of the machine.
2 Remove the drip tray with the coffee grounds container.
3 Open the service door (Fig. 21).
4 Press the PUSH button (Fig. 22) and pull at the grip of the brew group to remove it from the
machine (Fig. 23).
5 Remove the coffee residues drawer (Fig. 24).
Reinserting the brew group
Before you slide the brew group back into the machine, make sure it is in the correct position.
English
11