ENGINE / COOLING SYSTEM
28. Proceed to Flywheel Installation page 3.90 and then
Cylinder Head Installation page
STARTER ONE-WAY CLUTCH
ASSEMBLY
1. Install one-way clutch in clutch hub with flange of
q
clutch
engaged in recess.
2. Clean screw threads in flywheel to remove all oil or
grease.
3. Place one-way clutch on flywheel and install the three
screws. Torque screws to specification.
TORQUE
One-Way Clutch Retaining Screws:
9 ft-lb (12 Nm)
3.90
4. Reassemble starter one-way clutch and gear using
.
5. If starter gear was replaced, inspect the torque limit
6. After assembly, be sure the starter gear rotates in the
FLYWHEEL INSTALLATION
1. If previously removed, reinstall the flywheel key.
2. Inspect and clean crankshaft and flywheel taper with
the following illustration.
w
Torque Limit Gear
Pin
e
Starter Gear
r
Screws
t
Bolt
gear.
clockwise direction only.
isopropyl alcohol or similar cleaning solution.
Replace crankshaft if surface damage is present.
Clean taper of crankshaft to remove all oil or grease.
9930583 R02 - 2020 RZR PRO XP / XP 4 Service Manual
y
Flywheel
u
One-Way Clutch Asm
i
Torque Limit Gear
Asm
© Copyright Polaris Industries Inc.